Functions and Operation:
The m.unit can act as the central control unit in the vehicle’s electrical system. It provides the following features:
- Complete digital pushbutton control unit; optional 4 or 5 pushbutton operation
- Complete replacement of all OEM fuses. 10 independent circuits are digitally supervised; a circuit will be shut down in case of interference. On removing the interference, the safety feature will be automatically reset
- Integrated, digital, load-independent flasher relay; with programmable switch-off feature (optional), selectable m.wave mode
- Direction indicator setting for use as position light
- Parking light, high beam flasher
- Integrated digital brake-light modulator with programmable flashing sequence, acceleration controlled emergency brake-light
- Pairing of m.unit with other Motogadget products via LIN bus
- Integrated starter relay for solenoid switch (up to 30A switching capacity)
- Smart and fully configurable load control / shut-off for maximum starting power of battery on starting process
- Low and high beam control (up to 200W switching power) using just one pushbutton
- Integrated digital horn relay
- Integrated position-independent alarm system
- Integrated hazard light feature
- Diagnostic feature for layout of input, output, circuit switching status plus diagnosis of electrical circuit, short-circuits, etc.
- Two fully configurable auxiliary outputs AUX1 and AUX2
- Calibration and current monitoring allows defect detection of all lights and blinkers
Scope of supply:
- m.unit basic
- Approx. 500 mm (20") connecting cable for battery positive terminal with 10 mm² (7 Gauge) cross section
- 2 cable eyes
- 1 x M5 stainless steel bolt
- 2 x M5 stainless steel bolts with hex nuts
- Detailed installation and operating instructions
Dimensions and specifications:
- L/W/H: 101 x 61 x 28 mm (4" x 2.4" x 1.1")
- Weight: approx. 180 g
- Mounting: 2 x M5 screws, stainless steel (mounting and ground terminal), 1 x M5 screw-on terminal for battery positive
- Operating voltage: 6V - 20V
- Operating temperature: -20 °C... +80 °C
Inputs:
- 1 x input (+12V switched) for ignition lock or m.Lock
- 11 x control pilot inputs (minus/ground, switched) for left turn signal, right turn signal, low beam/high beam, starter, horn, brake light, kill switch, kick stand switch, LIN-Bus, AUX1 and AUX2
Outputs:
- 10 x Outputs (+12V) for left turn signal, right turn signal, Lo-beam, Hi-beam, starter, horn, brake light, ignition, AUX1 and AUX2
CLICK HERE TO DOWNLOAD M.UNIT INTRO PDF FILE