FXR DIVISION MOTORWITCH HANDLE BARS FOR ROAD GLIDE
FXR DIVISION MOTORWITCH HANDLE BARS FOR ROAD GLIDE
FXR Division worked Directly with one of the Industries Top Motor Builders to Design and Build a set of bars that would that give Him and You the Narrow Width (30.5” from end to end with a 12 Degree Wrist Angle which they have found that to be the closest to a Natural Wrist Position) and Stance of a T Bar, allow for a Direct Mount to your Factory Riser WITHOUT any need for expensive Gauge and/or Handlebar Relocation Plates, give FULL visibility of your gauges and Media Center, and hold up to the rigors of his performance riding abilities as well as his Built 151 Leading Edge Performance Equipped Motor.
Like the Split MX, Split Angle, and G Series Bars… they manufacture these IN HOUSE out of 1.250 X .125 steel tubing, while making sure to debur ALL material inside and out prior to welding for the smoothest wire pulls, and like ALL of our FXR Division Bars, are Throttle By Wire READY… YES… Your OEM Throttle By Wire fits PERFECTLY!!
ALL FXR Division Handle Bars are finished in a High Quality Gloss Black Powder Coat (CHROME IS NOT AVAILABLE AS IT HAS BECOME TOO EXPENSIVE AND DIFFICULT TO QUALITY CONTROL…Our customers have been purchasing our FXR Division Bars and Crash bars in Black and having them stripped and plated locally to them)
2015 to 2020 Road Glide Models:
12” OR 14” Motorwitch Bars DO NOT Require extending cables and/or lines… Your Stock Cables work just fine!!!
16” Bars DO require Extended Wiring and Hydraulic Clutch and Brake Lines.
2021 and Later RG Models:
You can run a 12” Motorwitch bar WITHOUT having to extend the OEM Clutch Cable, however you do need to do a little re-routing of the clutch cable…
14” Motorwitch Bars would require an +4 extended clutch cable…
For 16” Motorwitch would require a +6 Clutch Cable Extension, 60” Brake Hose, ABS Adapter, Straight Banjo Fitting and 42” Extended CanBus Wiring Kit...
** If your OEM Perch Clamp has a locating pin… it will be necessary to remove it before installation**
***We normally DO NOT stock bars over 16”… they are Made To Order and may take a little bit longer to manufacture and ship… Orders for Bars over 16” WILL BE subject to a 20% Cancellation Fee if order is cancelled after 7 Days from the Date the Order was placed***
We do our best to have ALL of the FXR Division bars IN STOCK. However, FXR Division Motorwitch Bars are in HIGH DEMAND and if they are not immediately available… then they are currently IN PRODUCTION.
If do not receive a Shipping Notification, with your tracking number within 1-3 business days… Then please allow 2-4 weeks for orders to ship.
ALL FXR DIVISION PARTS ARE PROUDLY MADE AND MANUFACTURED IN THE USA.